Chapter 10
Options & Accessories
DM55 DynaDrum PP V6, Manual No.21-18, Rev.2.19 Page 159
Chapter 10
Options & Accessories
Level Control Kit without Heated Ball Valve & Actuator Option, PN 806573
Used to automatically meter the flow of material from the Bulk Melter to the ASU. The kit
consists of a level control assembly and a modified Dynamelt M ASU lid assembly.
Heated 1” Ball Valve Option, PN 805732
Used with the PN 806573 Level Control Kit, the heated ball valve automatically opens the
valve to refill the hopper after manually being actuated.
Ball Valve Air Actuator Option, PN 806387
Used with the PN 806573 Level Control Kit and the PN 805732 Heated Ball Valve. The
ball valve actuator automatically actuates the ball valve to open the valve to refill the
hopper.
Pump Option
The standard pump for the Bulk Melter with Piston Pump is a PN 114350 Piston Pump
Assembly.
Full Clam Shell Option, PN 114126
The optional full-sized clam shell is recommended for all fiber drum applications.
It is designed to give support to and hold in place the fiber drum as its glue is emptied by
the Bulk Melter. It also guards against the spills that can occur when there are defects in
the drum.
Vent Hood Option, PN 114367
The vent hood kit provides for the connection of a stainless steel exhaust duct to carry
away adhesive fumes generated during drum exchange. The kit does not provide an
exhaust fan or tubing. Required for PUR adhesives.
Pressure Transducer Kit PN 114717, Transducer only PN 811475
A pressure transducer is an electronic probe that allows the melted adhesive’s pressure
to be processed by the ASU’s control system. They are used to monitor system operating
pressures and their limits. A variety of transducers are available.
Pallet Spacer Option, PN 114725
Pallet spacers (qty. 2) raise the Bulk Melter an additional five inches off the factory floor in
order to facilitate pallet loading of the machine. Customer-provided extended floor
anchors (qty. 4) are required.
Purge Valve Heater Option, PN 115502
Used in low temperature (less than 135°C/ 275°F) applications to keep the purge valve at
operating temperature. The optional purge valve heater is a single cartridge heater that
mounts onto the purge valve and functions as an auxiliary temperature zone.
To Next Page
Loading...