Chapter 3
Description and Technical Specs
Page 20 DM55 DynaDrum PP V6, Manual No.21-18, Rev.2.19
Residual Risks
In the design of the melter, every measure was taken to protect personnel from potential
danger. However, some residual risks cannot be avoided.
Personnel should be aware of the following:
• Risk of burns from hot material.
• Risk of burns from hot Bulk Melter components.
• Risk of burns when conducting maintenance and repair work for which the Melter must
be heated up.
• Risk of burns when attaching and removing heated hoses.
• Material fumes can be hazardous. Avoid inhalation. If necessary, exhaust material
vapors and/or provide sufficient ventilation of the location of the Melter.
• Risk of pinching parts of the body between platen and container. Ensure that, during
operation, no one else is near the bulk melter.
• The safety valve may malfunction due to hardened or charred material.
Technical changes
Any kind of technical changes having impact to the security or the operational liability of
the unit should only be done by written agreement of ITW Dynatec. Suchlike changes
made without given a corresponding written agreement will lead to immediate exclusion
of liability granted by ITW Dynatec for all direct and indirect subsequent damages.
Using foreign components
ITW Dynatec takes no responsibility for consequential damages caused by using foreign
components or controllers that have not been provided or installed by ITW Dynatec.
ITW Dynatec does not guarantee that foreign components or controllers used by the
operating company are compatible to the ITW Dynatec-unit.
Setting-up operation
We recommend asking for an ITW Dynatec-service technician for the setting-up
operation, to ensure a functioning unit. Let yourself and the people working with or
working on the unit be introduced to the unit on this occasion.
ITW Dynatec takes no responsibility for damages or faults caused by any untrained
personal.
To Next Page
Loading...