ITW Dynatec DM55 DynaDrum - Model Designation Guide

ITW Dynatec
Chapter 3
Description and Technical Specs
Page 26 DM55 DynaDrum PP V6, Manual No.21-18, Rev.2.19
3.4 Model Designation Guide
DM
55 X X X X X X X - XXXX…
* St
andard.
DM55 Bulk Adhesive Melter
SYSTEM TYPE:
P = Piston Pump System
G = Gear Pump System
VOLTAGE/ CONTROL:
2 = 240VAC, 3PH+PE, (DELTA), 50/60Hz,
DynaControl V6
3 = 400VAC, 3PH+N+PE, (WYE), 50/60Hz
DynaControl V6
4 = 480VAC, 3PH+PE, (DELTA), 50/60Hz,
DynaControl V6
PLATEN:
F = Finned, High Flow, Standard Air Inject
825428 *
R = Smooth, Vertical Air Inject 825427
(recommended for PUR)
BOTTOM PLATEN SEAL:
1 = 32x514 Platen Seal & Spacer*
2 = 32x512 Platen Seal & Spacer
3 = 32x510 Platen Seal & Spacer
4 = 32x505 Platen Seal & Spacer
TOP PLATEN SEAL:
T = T-Wiper Seal*
1 = 32x514 Platen Seal & Spacer
2 = 32x512 Platen Seal & Spacer
3 = 32x510 Platen Seal & Spacer
4 = 32x505 Platen Seal & Spacer
HOSE OUTPUT:
1 = Single-Hose Outlet Manifold, PUR
2 = Dual-Hose Outlet Manifold*
3 = Single-Hose Outlet Manifold, #24 JIC
4 = Single-Hose Outlet Manifold, Ball Valve Purge
5 = Dual-Hose Outlet Manifold, Ball Valve Purge
PUMP:
P = Piston Pump, 15:1*
2 = 30cc/rev Gear Pump
3 = 45cc/rev Gear Pump
4 = 8.5cc/rev Gear Pump
OPT
IONS:
B = Digital Pressure Transducer Kit
D = Fu
ll Clam Shell (required for
fiber drums) – 114126
G = Pal
let Height Spacer
I = Vent Hood (required for PUR)
J = Pr
ofinet 121436
K = Standard Platen Drip Tray & Hanger
- 114006 & 116622
L = Detachable Platen Guard
M = Platen circulation 823034
P
= Ethernet/IP 118925
Q = EtherCAT 118927
R = Profibus 118926
Y
= CC-Link
825749