ITW Dynatec DM55 DynaDrum - Description

Chapter 3
Description and Technical Specs
ITW Dynatec
DM55 DynaDrum PP V6, Manual No.21-18, Rev.2.19 Page 21
3.2 Description
The ITW Dynatec DM55 DynaDrum™ Bulk Adhesive Melter is a stationary melter that
combines a heated platen, pump and all controls needed to melt and dispense hot melt
adhesives, sealants, PURs or coatings from a standard 55-gallon steel drum.
The controller provides accurate, proportionate temperature control for the platen, hoses
and applicators. A “standby” temperature may be programmed so that the temperature
zones can be independently maintained at a lower temperature when the unit is not in
active use, enabling rapid return to normal operation.
An extremely dependable, pressure-balanced piston pump is standard. This air-operated
pump insures a high pressure adhesive output from a low pressure, compressed air
input. The Bulk Melter can be utilized as a bulk-transfer unit or as a stand-alone unit. It
can supply one or two hand-held applicators, distribution manifolds or applicator heads.
Illustration: DM55 with Piston Pump Components
Controller HMI
Emergency Stop
Purge Switch
Auto-Man Switch
Up-Down Switch
Pneumatic
Dashboard
Air-Inject-Button
Two-Hand-Control-
Buttons (Left & Right-
Confirm-Buttons)
Standard Half or
Full (Option) Fiber Drum
Clamshell
Guard
(Option)
Finned or
Flat (PUR) Platen
Hose Connection
Vent Hood
(Option
Ram Assembly
Junction Box
Hose Guide
System Status
Stacklight
Remote Purge
Actuator