Chapter 6
Controller V6 Touch
Page 48 DM55 DynaDrum PP V6, Manual No.21-18, Rev.2.19
6.2 Program Your System's Parameters
Program the controller parameters to meet the specific temperature requirements of your
production
.
Set points for each temperature zone must be programmed as well as a standby
temperature, pump enable temperature, temperature alarm window and temperature alarm
hysteresis.
Choices must be made for recipe (program) selection, pump (or motor) conditions and heating
priority
.
If desired, temperature zone offsets and/ or a temperature zone enable may be selected.
Numeric Entry Keypad
• Use the numeric entry keypad to enter or change numeric parameters (values).
• In the top window, the temperature zone name and its set point value will be displayed.
This is a typical example of the numeric entry keypad:
Item Description
1
By pressing the OK button the entered values will be confirmed and stored in the controller.
The numeric entry keypad closes and you will return to the previous screen.
2
By pressing the ESC button any entered but not yet confirmed values will be discarded and
you will return to the previous screen.
To Next Page
Loading...