ITW Dynatec DM55 DynaDrum - Specifications

Chapter 3
Description and Technical Specs
ITW Dynatec
DM55 DynaDrum PP V6, Manual No.21-18, Rev.2.19 Page 23
3.3 Specifications
Environmental:
Storage/ shipping temperature ........................................................ -20°C to 60°C (-4°F to 140°F)
Ambient service temperature .......................................................... -0°C to 45°C (32°F to 113°F)
Physical:
Dimensions ................................................................. see dimensional layouts on following page
Weight .................................................................................................................. 771kg (1700 lb)
Drum size ............................................................................... 208 liters (standard U.S. 55 gallon)
Drum diameter .................................... 564mm-570mm (22.2-22.5 inches), with or without chines
Piston pump/ air motor ratio (standard) ....................................... 15:1, pressure-balanced, Vector
Controller ..................................................................................................... HMI with Touch Panel
Hose .................................................................................................................. application specific
Performance:
Temperature range ..................................................................... 38°C to 204°C (100°F to 400°F)
Warm-up time ............................................................................................................... 32 minutes
Melt rate, maximum* .............................. up to 272 kg/hr (600 lb/hr), depending on adhesive used
Adhesive delivery ................................................................................. Continuous or On-Demand
Adhesive viscosity* ............................................................. 100 to 50.000 mPa. Sec. (centipoise)
* Flow rates of various materials are dependent on their physical characteristics
Adhesive pressure, maximum ........................................... 69 bar maximum (1000 psi maximum)
Maximum output rate: piston pump (standard) ............................................. 272 kg/hr (600 lb/hr)
Drum change time ........................................................................................... less than 5 minutes
Electrical:
Supply voltage (standard) ................................................................. 200-240 VAC/ 3p/ 50-60 Hz
(optional) .............................................................................................. 400 VAC/ 3p+N/ 50-60 Hz
(optional) .................................................................................................. 480 VAC/ 3p/ 50-60 Hz
Power requirements (240V), non-continuous ............................................................ 100 Amp, 3p
Power requirements (400V) ........................................................................................ 63 Amp, 3p
Power requirements (480V) ........................................................................................ 50 Amp, 3p
European power requirements (400V) ...............
“Wye”, “Y” or 5-wire connection must be customer-supplied
Wattage, maximum:
Platen .............................................................................................................. 36,000 Watts max.
Piston pump ....................................................................................................... 1170 Watts max.
Hand-h
eld applicator ............................................................................................ 200 Watts max.
Hose, applicator .................................................................................................. 1000 Watts max.
Hose, transfer ..................................................................................................... 2000 Watts max.
Piston Pump Pressurized Air:
Maximum air pressure supply ......................................................................... 8.22 bar (120 psig)
Maximum recommended pump speed ......................................................... 60 cycles per minute
Air consumption at 60 pump cycles per minute ....
548 liters/ minute @ 4.5 bar (19.4 CFM at 66 psig)
Air Requirements:
Operating air pressure range ............................................................. 1.4 to 5.5 bar (20 to 80 psi)