Chapter 6
Controller V6 Touch
DM55 DynaDrum PP V6, Manual No.21-18, Rev.2.19 Page 45
Chapter 6
Controller V6 Touch
for Dynamelt DM55 – Rev.8.18
6.1 Controller Set-Up
Helpful Tips for the User
• When the Bulk Melter is turned ON, all temperature setpoints and other operating
parameters will be exactly where they were when the Bulk Melter was turned off.
• When the Bulk Melter is turned ON, all system heaters go ON unless they have
previously been de-activated (in which case they will be turned OFF) or if sequential
heat-up have been set. However, if platen temperature is above ready temperature
when the Bulk Melter is turned on, all hose and head sequential heat-up will be
bypassed and hoses and heads will be turned ON.
• DO NOT damage the HMI’s touch panel with sharp-edged tools.
• DO NOT damage the touch panel by getting it wet.
•
Keep the touch panel clean.
DANGER HIGH VOLTAGE
Never open the control panel without switching off the main disconnect switch to ensure that
it is disconnected from its power source.
Temperature Control Functions in General
• The DynaControl microprocessor-based proportional temperature control in the Bulk
Melter performs a number of functions that help to maintain adhesive setpoints in all
temperature zones of the Bulk Melter system.
• It maintains permanent system values (fixed proportional and integration values that
have been programmed at the factory, such as the maximum temperature set point).
• It enables the user to program temperature settings and heater on/off sequencing that
are appropriate to a specific application.
• It displays all programmed values, and it includes self-diagnostic malfunction alerts
and failure alarms.
• Note: Some DynaControl functions are direct temperature conversions between
degrees Celsius and Fahrenheit. Other parameters are independently selected values.
Software & Hardware Versions
The software & hardware versions of your Controller and V6 modules are listed on the
Controller’s System Info Screen. At the HMI’s Main Screen, press the Settings button. On
the Settings Screen, press the System Info button.
To Next Page
Loading...