Chapter 5
Setting-up Operation, Daily Operation
DM55 DynaDrum PP V6, Manual No.21-18, Rev.2.19 Page 33
5.2 Setting-up operation, daily operation
Open/ Close the Main Panel Box Door
1. Turn main switch to OFF.
2. Release the two panel box door
screws.
3. Pull door open.
To close:
1. Turn main switch to OFF.
2. Close door.
3. Fasten the panel box door shut with a
screw driver.
To Turn Main Power On/Off
1. Verify that panel box door is locked
closed.
2. To turn main power on, turn the main
switch to “ON”.
3. To turn main power off, turn the main
switch to “OFF”.
Main Switch
Operating Switches and Buttons
1. Emergency Stop Pushbutton
An Emergency Stop button is located
beneath the controller screen, on the
control panel.
In case of an emergency or exceptional
incident, press the emergency stop
button in order to stop the unit quickly.
When activated, the Melter’s material
pumping and heating stop and the
platen stops in place. Pull out this
button for restarting the unit and
acknowledge on Touch Panel.
2. Purge Button
By manually pressing this button the
purge valve will be opened and allow
air/ adhesive to come out of the valve
in order to release trapped air from
under the platen.
The purge valve is automatically
activated 5 seconds later after the Air
Inject is activated.
3. Auto/Man-Switch
This switch toggles the Melter’s
operating mode to automatic or
manual.
4. Up/Down-Switch
This switch toggles the platen‘s
direction to up or down.
To Next Page
Loading...