Chapter 8
Troubleshooting
DM55 DynaDrum PP V6, Manual No.21-18, Rev.2.19 Page 135
8.4 Heaters in Platen Core
The platen core is located beneath the platen cover. An ohm reading for these heaters
can be made by removing the three heater inspection covers.
Six 6,000 Watt, cast-in heaters are installed within the platen core. An ohmmeter may be
used to verify if they are operable. A reading of 8.91 - 10.75 ohm indicates a heater is
good (allow a 5% increase if the heaters have been in use). These heaters are not
replaceable and should last the life of the Bulk Melter.
To Next Page
Loading...
