ITW Dynatec DM55 DynaDrum - Pump Control; Pressure Control Screen

ITW Dynatec
Chapter 6
Controller V6 Touch
Page 62 DM55 DynaDrum PP V6, Manual No.21-18, Rev.2.19
Pump Control/ Pressure Control Screen
 To go to this screen, press the Pump 2 field on the Pump Overview screen (to get to the Pump 1,
etc. Control screen, press the corresponding field). Then press the Settings button, select
Pressure Control in the Current Pump Mode menu on the Extended Pump Mode Settings screen
and then press the BACK button.
 If (optional) pressure sensors (transducers) are installed on the unit, the pumps can be pressure
controlled. Pressure values (Bar/PSI) will be displayed on the Main Screen.
Pump 1 Example at DM55 with Gear Pump:
Item Description
1
Pump #1 is the selected pump. All the settings and speeds displayed on this screen
correspond to Pump #1.
2
Auto Mode Settings:
Press the according switch for pump control. The activated switch is highlighted green.
• Use Master Pump Control: The selected pump will use the START/STOP signal that
pump #1 uses.
• Use Independent Pump Control: The selected pump will use its own START/STOP
signal.
3
Setpoint (if in Auto Mode only)
The minimum and maximum setpoint RPM of the pump are displayed as programmed.
Press the input field to edit the values.
7
1
9
3
4
10
11
5
6
8
12
2
#1