ITW Dynatec DM55 DynaDrum - Recipes Screen

Chapter 6
Controller V6 Touch
ITW Dynatec
DM55 DynaDrum PP V6, Manual No.21-18, Rev.2.19 Page 89
Recipes Screen
 To go to this screen, press the Recipes button on the Settings Screen.
 This screen allows you to create recipes (or “programs”). A recipe is a set of temperature set
points and parameters which the user has programmed and stored in the controller for future use.
Up to ten recipes may be stored in the V6 controller.
Item Description
1
To Create and Save a Recipe:
1. Program the controller as you wish it to be setup for a recipe. Program the following
parameters: temperature settings, zone On/Off settings, motor mode and speed.
2. Using the up and down arrows, select a number to assign to your recipe.
3. Press the “Adhesive Unit to SD” button. The recipe will be saved.
To Load a Saved Recipe:
1. Using the up and down arrows, select a recipe number.
2. Press the “SD to Adhesive Unit” button. The recipe will be loaded and the
saved parameters will be set.
2
Recipe Name
Touch the input box and an Alphabetic Entry Keypad will appear. Enter your desired name and
confirm by pressing OK.
3
Recipe Autoload
This function may be activated or deactivated by pressing the Active button.
If activated, up to four recipes (always the first four saved recipes) can be loaded individually
and automatically by addressing the digital inputs IN3 and IN2 on the Controller-Module via a
parent machine controller, as indicated on the table shown above.
1
3
4
7
2
5
6