Chapter 6
Controller V6 Touch
DM55 DynaDrum PP V6, Manual No.21-18, Rev.2.19 Page 111
V6 Motor Module PN 116823
A maximum of two V6 MOTOR modules may be installed on the ASU. Each motor
module controls up to four motors. Each motor control output is associated with an
enable contact and an encoder input. A wide variety of encoders (ie. a ring kit) may be
adapted to the input.
Each motor may be assigned its individual line speed input, but it is also possible to use a
common line speed input. This also applies to the pump enable input. Each motor module
has four pressure transducer inputs; transducer type is 4-20mA. One or two pressure
transducers may be assigned to each motor.
Motor #1 on the first Motor Module = pump #2 in the system (pump #1 is on the Base
Module).
To Next Page
Loading...
