ITW Dynatec DM55 DynaDrum - Platen Options; Platen Seal Options; Platen Guard, PN 116967

ITW Dynatec
Chapter 10
Options & Accessories
Page 160 DM55 DynaDrum PP V6, Manual No.21-18, Rev.2.19
Platen Options
• PN 113977 Platen Face, Finned: standard.
• PN 114091 Platen Face, Smooth: built without fins for adhesives with lower softening
points, including PUR or aggressive adhesives.
• PN 116468 Platen Face, High Viscosity.
Platen Seal Options
• The Bulk Melter configuration consists of two platen seals, one above the platen core
and one below it.
• The PN 114056 T-Wiper Seal is the seal used above the platen and a second seal
(chosen from the following chart) is below it.
• All other configurations are application specific and require consultation with ITW
Dynatec engineering.
• PN 115960 Seal Kit, Smooth, consists of:
Part Number Description Qty. per Unit
115959 Smooth Platen Seal 1
L01389 Hose Clamp Assy. 1
• PN 114272 T-Wiper Kit, consists of:
Part Number Description Qty. per Unit
114056 T-Wiper Seal 1
114712 T-Wiper Band Clamp 2
• PN 116488 Wound (Steam Hose) Seal Kit, consists of:
Part Number Description Qty. per Unit
815714 Steam Hose Seal 1
L01389 Hose Clamp Assy. 1
• Encapsulated O-ring Seal (standard):
Part Number Description Qty. per Unit
116922
Platen Seal, 505.6mm (requires PN 116881 Seal
Spacer) Fits drum diameters 22.0 inch (559.0 mm) to
22.5 inch (572.0 mm).
1
Platen Guard, PN 116967
An expanded metal, removable guard that spans the vertical distance from the top of the
drum to the top of the platen cover (when in the fully-up position). Prevents accidental
pinch point and protects against potential splatter.