ITW Dynatec DM55 DynaDrum - Accessing, Programming and Monitoring Motor Control Parameters

Chapter 8
Troubleshooting
ITW Dynatec
DM55 DynaDrum PP V6, Manual No.21-18, Rev.2.19 Page 139
8.9 Accessing, Programming and Monitoring Motor Control
Parameters
To Access and Change Parameter Values
To access other drive signals, refer to the Yaskawa technical manual, available at:
http://www.yaskawa.com/site/products.nsf/productGroup/ACDrives.html
J1000 Digital Operator power-up state
Step 1.
Press the key once. The digital operator
shows the parameter menu (PAr),
then press the key.
Step 2.
Press the key to select the digit you would
like to change. Next use the and keys
to select the parameter group, sub-group or
number, then press the key.
Step 3.
Press the key to select the digit you would
like to change. Modify the parameter value using
the and hey and press the key
to save the new value.