ITW Dynatec DM55 DynaDrum - Page 85

Chapter 6
Controller V6 Touch
ITW Dynatec
DM55 DynaDrum PP V6, Manual No.21-18, Rev.2.19 Page 85
Calibrating Screen
Item Description
1
Parameter Selection tabs
The Pressure Zero Calibration tab has been selected.
2
Pressure Zero Calibration
If (optional) pressure sensors are installed on the unit, the pumps can be pressure controlled.
Pressure values will be displayed on the Main Screen. Refer to Pump Control, Pressure
Control. Primary and Secondary Pressure Ports are displayed on the screen. Calibrate each
pump to zero by pressing the appropriate "Cal" button. Note: before calibrating pressure
transducers, all pumps must be in STOP mode and the system must be fully depressurized.
3
Calibrate All
Press the Calibrate All button to calibrate all pumps to zero at one time. Note: before
calibrating pressure transducers, all pumps must be in STOP mode and the system must be
fully depressurized.
4 Press the left-pointing arrow to go to the previous General Settings screen.
5 Press the right-pointing arrow to go to the next General Settings screen.
6 Press the OK button to confirm your entered values and return to the previous screen.
7 Press the ESC button to discard any non-confirmed values and return to the previous screen.
6
7
1
2
4
5
3