Chapter 8
Troubleshooting
Page 130 DM55 DynaDrum PP V6, Manual No.21-18, Rev.2.19
Restoring Level Detector Synchronicity
The level detector sensors may get out of sync due to power interruptions or due to
manual movement of the ram when the controller is not turned on.
To restore synchronicity, manually cycle the ram using the ram cylinder valve located
behind the pneumatic control board (see illustration). Depress the Ram Cylinder Up
pushbutton at the top of the valve while manually moving the ram to its upper limit. Then
depress the Ram Cylinder Down pushbutton while manually moving the ram to its lower
limit.
To Manually Remove Ram from Drum of Adhesive
If it becomes necessary to manually remove the ram from a drum of adhesive, depress
the Air Injection Override pushbutton (at the top of the air inject valve, see illustration) and
the Ram Cylinder Up pushbutton on the ram cylinder valve before manually raising the
ram.
To Next Page
Loading...
