ITW Dynatec DM55 DynaDrum - Page 220

ACCESSORIES
Connectors
6-pin mating connector (IP65 protection degree) CON300
8-pin mating connector CON307
Accessories
Mounting bracket SF18
Dummy plug for 1/2-20UNF SC12
Dummy plug for M18x1.5 SC18
Drill kit for 1/2-20UNF KF12
Drill kit for M18x1.5 KF18
Cleaning kit for 1/2-20UNF CT12
Cleaning kit for M18x1.5 CT18
Thermocouple for WE2 model
Type “J” (153mm - 6” stem) TTER 601
Extension cables
6-pin connector with 8m (25ft) cable C08WLS
6-pin connector with 15m (50ft) cable C15WLS
6-pin connector with 25m (75ft) cable C25WLS
6-pin connector with 30m (100ft) cable C30WLS
8-pin connector with 8m (25ft) cable E08WLS
8-pin connector with 15m (50ft) cable E15WLS
8-pin connector with 25m (75ft) cable E25WLS
8-pin connector with 30m (100ft) cable E30WLS
Other lengths consult factory
42 [1.65"]
The Autozero function
is activated through a
magnetic contact (exter-
nal magnet supplied with
the sensor).
See the manual for a
complete Autozero fun-
ction explanation.
The diagram shows the optimum ratio between the
load and supply voltage of the 4...20mA transmitter.
For a correct use, choose any combination of load
resistance and supply voltage, in the shaded area.
ELECTRICAL CONNECTIONS
AUTOZERO FUNCTIONLOAD DIAGRAM
CURRENT OUTPUT (4...20mA, two wires)
6-pin 8-pin
A
C
B
D
E - F
B
A
D
C
E - F
G - H
n.c.
CONTROLLER
AMPL./CONV.
n.c.
n.c.
Supply voltage
(10...30Vdc)
+
-
Signal
(4...20mA)
Calibration shunt
Shield drain wire is tied to
connector via cable clamp
6-pin 8-pin
A
C
B
D
E - F
B
A
D
C
E - F
G - H
n.c.
n.c.
n.c.
-
Supply voltage
(10...30Vdc)
Signal
(4...20mA)
Autozero
+
MAGNETIC
AUTOZERO
EXTERNAL
AUTOZERO
6 pin connector
VPT07RA10-6PT2
(PT02A-10-6P)
8 pin connector
PC02E-12-8P Bendix
SUPPLY VOLTAGE
LOAD RESISTANCE Rl
Cable color code
6 wires
Conn. Wire
A Red
B Black
C White
D Green
E Blue
F Orange
Cable color code
8 wires
Conn. Wire
A White
B Red
C Green
D Black
E Blue
F Orange
G n.c.
H n.c.