Chapter 6
Controller V6 Touch
DM55 DynaDrum PP V6, Manual No.21-18, Rev.2.19 Page 59
Item Description
5
Set the pump to the desired mode by pressing MANUAL, OFF (STOP) or AUTO.
• MANUAL: The pump speed is adjusted manually by the operator. If MANUAL is selected
the icon is highlighted green.
• OFF (STOP): The pump is stopped, until AUTO or MANUAL is selected. If OFF is selected
the icon is highlighted red.
• AUTO: The pump speed is controlled via a 0–10VDC signal that is provided by an external
device (pattern control equipment or parent machine input). If AUTO is selected the icon is
highlighted green.
A minimum speed is necessary to keep the pump turning in order to maintain a minimum
amount of adhesive pressure through the hose and applicator head.
For instance, if the input signal is 10VDC at 100 meters per minute and the pump
percentage of full speed is 100% (maximum speed), but the system is putting out too much
adhesive, adjusting the MAX pump percentage to 50 will cause the pump to slow down over
the parent machine’s entire speed range and adhesive output will be decreased.
6
Press this button to go to the Extended Pump Mode Settings screen where you can select the
Current Pump Mode "Linear Line Speed" or "Pressure Control" and you can go to the
"Automatic Ramp Compensation" screen.
7
BACK Button
Press to return to the previous screen.
8 LINE SPEED: The actual (or calculated) line speed is displayed.
9 PRESSURE: The actual pressures are displayed. See explanation under Main Screen point 4.
10 SPEED: The actual (or calculated) pump speed is displayed.
Pump Control Screen Example at DM55 with Piston Pump:
To Next Page
Loading...
