ITW Dynatec DM55 DynaDrum - Page 67

Chapter 6
Controller V6 Touch
ITW Dynatec
DM55 DynaDrum PP V6, Manual No.21-18, Rev.2.19 Page 67
Item Description
1
Standby Switch
• Press the Standby switch to activate or deactivate the standby condition. When Standby is
activated, the button will be highlighted blue.
• When Standby is activated, all zone temperatures will be set to the standby value
(programmed on the General Settings Screen) and all pumps will be disabled.
2
On/Off Switch
Press the On/Off button to toggle the system On or Off. When the system is On, the button will
be highlighted green. When the system is Off, the button will be highlighted red.
3
BACK Button
Press to return to the previous screen.