Chapter 6
Controller V6 Touch
DM55 DynaDrum PP V6, Manual No.21-18, Rev.2.19 Page 81
Step 3:
Item Description
1
Parameter Selection tabs
The Standby Settings tab has been selected.
2
Note: This procedure is needed only if drum size has been changed.
Step 1: Move platen to lowest position and press SET button.
Step 2: Move platen to highest position and press SET button.
Step 3: Move platen to position where lower seal touches drum surface and press SET button.
3 Press the left-pointing arrow to go to the previous General Settings screen.
4 Press the right-pointing arrow to go to the next General Settings screen.
5 Press the OK button to confirm your entered values and return to the previous screen.
6 Press the ESC button to discard any non-confirmed values and return to the previous screen.
To Next Page
Loading...
