Engineering manual - UniSAB III 1.10.8
12/346
001930 en 2021.06
6.6.5 Function interface ............................................................. 255
6.6.6 E-mail .............................................................................. 257
6.6.7 Language......................................................................... 257
7. Calibration......................................................................................... 258
7.1 Before start-up......................................................................... 258
7.2 Pressure transducers ............................................................... 258
7.3 Temperature sensors (process out temperature) ........................ 260
7.4 Motor ...................................................................................... 260
7.4.1 Motor frequency signal ...................................................... 260
7.4.2 Motor current.................................................................... 260
7.5 Position transmitters for hydraulic slide systems (screw
compressors)
.......................................................................... 261
7.5.1 Calibration procedure for position transmitters .................... 262
7.5.2 Capacity slide adjustment, manual Vi ................................. 262
7.5.3 Capacity slide adjustment, auto zero point .......................... 262
7.5.4 Capacity slide adjustment, auto Vi...................................... 262
7.5.5 Volume ratio slide adjustment, auto Vi ................................ 263
7.5.6 Adjusting turning transmitter .............................................. 264
7.5.7 Adjusting long-stroke capacity rod...................................... 265
7.5.8 Adjusting long-stroke capacity rod for SAB 283 Mk 1 ........... 266
7.5.9 Adjusting short-stroke capacity rod for Gram GST, GSV
and RWF and short-stroke volume transmitter for GSV, RWF
and SAB 283 Mk 1 and SAB 355 Mk 1
................................ 266
7.5.10 Adjusting long-stroke capacity rod for SAB 193-233-283
and SAB 355
.................................................................... 267
7.5.11 Adjusting short-stroke volume transmitter for SAB 193-
233-283 and SAB 355
....................................................... 268
7.5.12 Adjusting short-stroke capacity rod for SAB 120 and SAB
151
.................................................................................. 268
7.5.13 Adjusting long-stroke capacity rod for SAB 193 H-233 H-
283 H-355 H
..................................................................... 268
7.5.14 Software calibration, hydraulic slide systems ...................... 270
7.6 Electrical slide systems (certain screw compressors).................. 271
7.6.1 Manual slide positioning .................................................... 271
7.6.2 Transmitter adjustment...................................................... 271
7.6.3 Software calibration, electrical slide systems....................... 272
8. UniSAB III (boot) and communication set-up..................................... 273
8.1 Introduction ............................................................................. 273
8.2 Enter boot loader ..................................................................... 273
8.3 Update.................................................................................... 273
8.3.1 Uploading new software version......................................... 278
8.3.2 Uploading configuration..................................................... 279
To Next Page
Loading...
