Engineering manual - UniSAB III 1.10.8
001930 en 2021.06
253/346
Set-up
6.6 Session
6.6.1 Password
In this picture the password can be entered and changed.
In the line Current user you can log into UniSAB III. First choose the appropriate user level and then en-
ter your password. In the line Change passwords you may change the password for Current user level,
i.e. the level you are currently logged into. Make sure you remember your new password. See also sub-
section 1.2.5 Session, Password.
6.6.2 Serial number
This picture shows some commissioning information.
The compressor serial number and the date of compressor commissioning (date of initial start-up) can
be read.
6.6.3 Remote connect
In this picture you may set up a Remote TCP/IP connection to another UniSAB III for remote control or
local (internal) TCP/IP connection to a software simulator.
In the first four lines you must enter the IP number for the UniSAB III you want to control remotely.