Engineering manual - UniSAB III 1.10.8
001930 en 2021.06
227/346
Set-up
6.4.9 Aux. output
See section 3.5 Compressor control - user functions.
6.4.10 R000
See section 3.5 Compressor control - user functions.
6.4.11 Calibration
See chapter 7. Calibration.
6.4.12 Quick Setup
The Quick Setup menu is intended for UniSAB III commissioning.
All configuration parameters that initiate a software reset or a software restart are collected in this Quick
Setup menu. In this menu you can change all parameters to the wanted setting with a and first when
you leave the menu by pressing the parameters are changed and a software restart is performed. De-
pending on which parameters have been changed a software reset to factory settings may also be
performed.
To Next Page
Loading...
