Engineering manual - UniSAB III 1.10.8
001930 en 2021.06
169/346
Service
5.1.4 Remote monitoring
A Remote Monitoring E-mail function has been introduced in UniSAB III. This function enables UniSAB
III to report compressor operation and events i.e. trend files, shutdowns and alarms for central remote
monitoring.
This picture shows the set-up parameters for Remote Monitoring. Remote monitoring must be set to Yes
to enable Trend and Events to the remote monitor server.
Note: Before Remote mon. can be configured to Yes the Remote monitoring functionality must have
been previously activated. See subsection 6.6.5 Function interface.
Service/Remote monitoring
No. Function Use
Choices
1
Remote monitoring
1/2
No, Yes
2
Retries
(max. no of monitor and user mail retries)
1/2
3, [1-10]
3
Port (SMTP port no.)
1/2
25, [1-32000]
4 Heartbeat 1/2
4, [1-24]
5
Alarm
(enable Alarm info to remote monitoring)
1/2
No, Yes
6
Max. hour
(max. no. of event mails per hour)
1/2
30, [1-120]
With the default setting 30, the minimum
time to elapse between two consecutive
event mails will be 60/30 = 2 minutes.
7
Last e-mail
(status information for last sent e-mail)
1/2
Nothing sent, Success, Invalid Sender, In-
valid recipient, No connection, DNS error,
Authentication method, Authentication
failed, Discarded
Last e-mail status
Nothing sent No e-mail has been dispatched.
Success Last e-mail transmission was OK.
Invalid Sender UniSAB III e-mail settings are not correct.
Invalid Recipient Recipients e-mail settings are not correct.
No connection It is not possible to establish connection to e-mail server.
DNS error DNS server IP address is not correct or the server is not available.
Authentication method
Connection was rejected because UniSAB III did not support the re-
quested e-mail server authentication method.
Authentication failed Connection to e-mail server was rejected during the authentication
session.
Discarded Last e-mail transmission has been interrupted during dispatch and the
number of Retries was exceeded.
The cause is probably a bad or unstable connection to e-mail server.
To Next Page
Loading...
Need help?
General
