Johnson Controls SABROE UniSAB III - Contrast (Display); File System

Engineering manual - UniSAB III 1.10.8
001930 en 2021.06
283/346
UniSAB III (boot) and communication set-up
8.4.3 File system
Press /File system to find information about the internal flash memory and the external flash card
memory.
The picture above contains file information for the SD card.
The picture above contains file information for the internal flash memory.
Press /Format to go to the picture below:
In this picture you can format (erase) the internal flash memory.
Note: All software information, i.e. all settings, languages etc will be lost after this command.
8.4.4 Contrast (display)
Press /Contrast to find information about the contrast setting.
The contrast setting of the display happens automatically but it is possible to make a manual
adjustment.
The display contrast may be adjusted in this picture:
F3
F4
F4