Johnson Controls SABROE UniSAB III User Manual

Engineering manual - UniSAB III 1.10.8
001930 en 2021.06
37/346
UniSAB III control
1.2.10 Factory settings
On delivery UniSAB III is preset with factory settings for all appropriate points. Although other values
may have been entered from factory or after delivery, UniSAB III can always be reset to its factory set-
tings. A factory reset affects the following points:
• Alarm and shutdown limits
• Regulator settings
• Timer setup
• Control mode
The factory settings are stated in the tables in the sections Alarms and shutdowns, Timers and Com-
pressor regulation (Engineering manual). Before performing a factory reset, always stop the compres-
sor for safety reasons. Select Setup/Configuration/Factory Reset and change Factory Reset from No to
Yes.
Now press and within a few seconds UniSAB III will restart and display the Favourites/Default picture
shown in Fig. 1. The reset operation is complete and UniSAB III is now restored to its factory settings.
UniSAB III must then be adjusted to the actual operating conditions. Remember to fill in the forms for ac-
tual settings before making a factory reset. These forms (Settings for UniSAB III) are included in the
back of this manual.

Johnson Controls SABROE UniSAB III Specifications

General

Brand	Johnson Controls
Model	SABROE UniSAB III
Category	Control Systems
Language	English