Johnson Controls SABROE UniSAB III User Manual

Engineering manual - UniSAB III 1.10.8
001930 en 2021.06
281/346
UniSAB III (boot) and communication set-up
8.4.2 Ethernet, IP address set-up
Press /Ethernet for information about Ethernet port set-up.
To change the Ethernet set-up, press /Modify.
To change the IP addresses, press .
Change the number using the F keys or the arrow keys, and press .
In the same way you can set the appropriate subnet mask and gateway address. The subnet mask must
be the exact same on all UniSAB III units and possible PC/routers on the LAN (Ethernet) network.
The gateway address must be set to an IP address which matches the address of the LAN network, i.e.
the PC/router on the first three segments.
The DNS server address must be set to an IP address which matches the address of an optional DNS
server.
It is not necessary to change the broadcast address. When all settings are OK press and /Escape.
UniSAB III will now be restarted with the new settings.
F2
F1

Johnson Controls SABROE UniSAB III Specifications

General

Brand	Johnson Controls
Model	SABROE UniSAB III
Category	Control Systems
Language	English