EasyManua.ls Logo

JRC JLR-7500 - Page 120

JRC JLR-7500
216 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
4-76
(3) DGPS
7. Press
"DGPS".
8. Press to select "OFF" or the alarm trigger state, and press
.
ON OFF: An alarm will sound when DGPS positioning switches to GPS positioning.
OFF ON: An alarm will sound when GPS positioning switches to DGPS positioning.
ON OFF An alarm will sound when DGPS positioning switches to GPS positioning, or
when GPS positioning switches to DGPS positioning.
(4) HDOP
9. Press
"HDOP".
10. Press to select "OFF" or "SET", and press
.
11. Enter the HDOP value with the numeric keypad, and press
.
An alarm sounds when the GPS positioning HDOP value exceeds the set value.
(5) TEMP
12. Press
"TEMP".
13. Press to select "OFF" or "RANGE", and press
.
14. Enter the water temperature with the numeric keypad, and press
.
OVER: An alarm will sound when the water temperature exceeds the set value.
UNDER: An alarm will sound when the water temperature falls below the set value.
IN RANGE: An alarm will sound when the water temperature is within the set range.
OUT RANGE: An alarm will sound when the water temperature is outside the set range.
Water temperature data must be obtained from externally connected equipment for the water
temperature alarm to be used.
(6) DEPTH
15. Press
"DEPTH".
16. Press to select "OFF" or "RANGE", and press
.
17. Enter the water depth with the numeric keypad, and press
.
OVER: An alarm will sound when the water depth exceeds the set value.
UNDER: An alarm will sound when the water depth falls below the set value.
IN RANGE: An alarm will sound when the water depth is within the set range.
OUT RANGE: An alarm will sound when the water depth is outside the set range.
Water depth data must be obtained from externally connected equipment for the water depth
alarm to be used.
(7) TRIP
18. Press
"TRIP".
19. Press to select "OFF" or "SET", and press
.
20. Use the numeric keypad to enter the trip distance, and press
.
An alarm will sound if the set trip distance value is exceeded. The trip distance is calculated
using the total distance over ground from Navigation Assistance 1 screen.

Table of Contents

Other manuals for JRC JLR-7500

Related product manuals