4-50
6. When "UNICAST" is selected, press
and to select the Destination IP "TO IP"
and "PORT No.".
7.
Press "FORMAT".
8. Press
to select "SHARE ROUTE", and press .
9.
Press "OUT TYPE".
10. Press
to select the output data, and press .
The following is an overview of the output data submenu.
(1) ALL: Output all routes between 1 and 101.
(2) ROUTE LIST: Select a range on the route list to be output.
(3) ROUTE No.: Specify the route number to be sent with the numeric keypad.
(4) FROM TO: Enter the start and end points of the range to be sent with the numeric
keypad.
Please refer to "4.8.3 Selecting a Range within a List" for details regarding range selection.
11.
Press "START".
12. The following will be displayed. Select "YES", and press
.
To Next Page
Loading...
