FX-1/FX-1R Maintenance Manual
[7] ATC .........................................................................................................7-1
7-1. Replacing the Air Cylinder.....................................................................................7-1
7-2. Replacing the ATC OPEN and CLOSE Sensors...................................................7-4
7-3. Adjusting the Speed Controller..............................................................................7-4
[8] FEEDER BANK AND REPLACEMENT TABLE (OPTIONAL).................8-1
8-1. Overall Drawing.....................................................................................................8-1
8-2. Replacing the Drive Cylinder.................................................................................8-2
8-3. Adjusting the Speed Controller of the Drive Cylinder ............................................8-4
8-4. Replacing the Feeder Bank Board and Feeder I/F Board .....................................8-5
8-5. Replacing the Bank-Up Cylinder ...........................................................................8-6
8-6. Adjusting the Speed Controller of the Bank-Up Cylinder
(Optional Replacement Table) ..............................................................................8-7
8-7. Replacing the Bank-Up Detection Sensor (Optional Replacement Table) ............8-8
8-8. Replacing the Selector Switch (Optional Replacement Table)..............................8-9
8-9. Replacing the Roller Lever (Optional Replacement Table) .................................8-10
[9] PNEUMATIC UNITS ...............................................................................9-1
9-1. Replacing the Main Pressure Detection Cable Assembly .....................................9-1
9-2. Replacing the Filter Element .................................................................................9-2
[10] SWITCHES ...........................................................................................10-1
10-1. Replacing the Push-Button Switch ......................................................................10-1
10-2. Replacing the EMERGENCY STOP Switch ........................................................10-3
10-3. Replacing the Cover Open Switch ......................................................................10-5
10-3-1. Switch Main Unit ................................................................................................................ 10-5
10-3-2. Operation Key .................................................................................................................... 10-6
[11] REPLACING AND ADJUSTING THE FEEDER FLOAT SENSOR........ 11-1
[12] OTHER UNITS......................................................................................12-1
12-1. Replacing the FDD (Floppy Disk Drive) ..............................................................12-1
12-2. Replacing the CD-ROM Drive .............................................................................12-2
12-3. Replacing the LCD Monitor .................................................................................12-3
12-3-1. Replacing the LCD Monitor ................................................................................................ 12-3
12-3-2. Setting up the touch panel (optional) ................................................................................. 12-4
12-3-3. Replacing the LCD back light............................................................................................. 12-5
12-3-4. Adjusting the LCD .............................................................................................................. 12-6
12-4. Replacing the SSD..............................................................................................12-8
12-4-1. Required Components ....................................................................................................... 12-8
12-4-2. Replacing the HDD ............................................................................................................ 12-9
iv
Rev. 2.00