FX-1/FX-1R Maintenance Manual
13-4-7. BASE FEEDER Board Assembly (40007370)
[Functions]
This BASE FEEDER board provides various functions, such as the feeder knock, signal light
control, and head I/F.
[Switch settings]
Jumper switches are provided on the BaseFeeder board assembly to be used in the control unit.
Set these jumper switches correctly while referring to the table below. (Jumper line is mounted on
the painted portion.)
362 142 122
1131111
14
W2 W3 W4
22 6323232
115111
111
W5 W6 W7 W8 W9 W10 W11 W12
W1
Set to OFF all the dip switches on the switch 1.
Use the switch 2 to set the function Rev. and pattern Rev. of the board. The following figure
shows the assignment and weight of each bit. The setting shown in this figure means that the
function Rev. is set at “02” and the pattern Rev. is set at “02”.
ON
OFF
18
SW1
ON
OFF
18
機能Ｒｅｖ．設定
パターンＲｅｖ．設定
2
0
2
2
2
1
2
3
2
0
2
2
2
1
2
3
SW1
Pattern Rev. setting
Function Rev. setting
13-14
Rev. 2.00
To Next Page
Loading...
Need help?
General
