JUKI FX-1 - Replacing the Plastic Rail; Replacing the X-Axis Plastic Rail

FX-1/FX-1R Maintenance Manual
1-7. Replacing the Plastic Rail
1-7-1. Replacing the X-Axis Plastic Rail
(1) Remove the SM0050801SC and SM0061201SC.
(2) Open the flap of the X cable bear to remove the cables, and replace the X-axis plastic rail.
(3) Apply the grease to four surfaces inside the plastic rail thickly and evenly.
(The reference-applying amount is that the whitish grease can be seen.)
(4) Reassemble the components in the reverse order of disassembly. At this time, pay special
attention so that
the cables in the plastic rail are properly arranged and not entangled.

When applying the grease, check the cables inside the plastic rail. When
necessary, apply the grease again.
X Cable Bare: L131E321000
Figure 1-7-1-1
1-10
Rev. 2.00