FX-1/FX-1R Maintenance Manual
12-4-4. Setting Up the Network (This setup is performed when communicating with the
HLC)
It is necessary to set up the network to perform the communication between the FX-1/FX-1R-series
and HLC. You must always set up the network to use the HLC in the on-line mode.
<Setting procedures>
c Setting up the TCP/IP
d Setting up a shared folder
e Registering a user
Note) The setting up procedures of WindowsNT are different from those of WindowsXP. When
using WindowsNT, refer to the setting up procedures stated in sections 12-4-4-1 to
12-4-4-3. When using WindowsXP, refer to the setting up procedures stated in sections
12-4-4-4 to 12-4-4-6.
12-4-4-1. Setting Up the TCP/IP (WindowsNT)
(1) From the Start button, select [Settings], and then [Control Panel].
(2) Double-click the [Network] icon.
12-13
Rev. 2.00