4 Introduction
CAUTION
When using the battery
Follow the instructions given on the label or a package of the
battery. Misuse of the batteries may cause leakage, overheating,
explosion, injury, or damage to the device.
Auto-cutter
Keep your fingers off the exit slot where the labels come out during
printing or when the cutter is operating. This may cut your fingers.
Other
Do not put anything heavy on
LABELShop
£
BEE3 or leave it in
unstable position. This may cause injury or damage to the device.
Always turn the power off before removing the AC adapter
from the electrical outlet. This may cause malfunction of the device.
About the labels
Before attaching labels, be sure to check the purpose of use and
the material of the adhered surface. Depending on the material,
environmental conditions, etc., following problems may occur.
x Color of the labels change
x Labels come off
x Texts on the label wear off
x Cannot peel off the labels
x Glue remains on the adhered surface
x The adhered surface absorbs the color of the label
x The adhered surface is damaged
We shall not be liable for any damages, losses, costs, or expenses
arising from these problems.
Instructions
Check
To Next Page
Loading...
