Appendix 107
Problems and Solutions
The device does not
operate normally
LABELShop
£
BEE3 is a electronics device
and may rarely malfunctions due to static
electricity or other causes.
If the display is distorted, if you cannot turn
on/off the power, or a similar malfunction
occurs, you need to reset the device.
See "Resetting LABELShop
£
BEE3"
(p.96).
Nothing appears on the
display even after
pressing
Is the AC adapter connected firmly?
The AC adapter should be connected both
to the device and the electrical outlet firmly.
Are the batteries installed with correct
polarity?
The device does not turn on when the
batteries are installed with its and
terminals reversed. Make sure to install the
batteries correctly.
Are you using the authorized AC adapter?
Use of the non-authorized AC adapter with the
LABELShop
£
BEE3 may overheat or
damage the circuit of the device.
Have the batteries run out?
The device may not turn on when the
batteries are running low. Replace them
with new batteries.
Is the display level appropriate?
The text on the display may become
invisible depending on the
display level setting.
Adjust the setting on the display level
to a comfortable eye level.
See "Adjusting Display Level" (p.22).
Display turns off
unexpectedly
Is auto power-off active?
If there is no activity for approx. five
minutes, the LABELShop
£
BEE3
automatically shuts down in order to save
battery power (auto power-off).
Did you make any mistakes?
Display turns out for a moment when you
make a mistake in key operations.
Nothing is printed when
pressing
Is text entered?
Nothing is printed when there is no text in
the text enter screen or in a fixed form.
Is there any message on display?
Printing is not carried out when an error
message is displayed on the display.
See "Messages On the Display"
(p.105).
Please wait for a second when a message;
"Wait" is displayed.
Is the tape cartridge installed
correctly?
You cannot print when there is no
remaining tape in the tape cartridge or
when the top cover is not closed properly.
Install a tape cartridge and close the top
cover firmly.
To Next Page
Loading...
