10.3.3.3 Fuel filter maintenance
Changing the fuel prefilter:
Fig. 52 Changing the fuel pre-filter.
1 Fuel hose
2 Hose clamp
3 Fuel pre-filter
1. Place a receptacle beneath the fuel pre-filter housing.
2.
Loosen the hose clamps, carefully pull the fuel hoses from the connection at the fuel pre-filter.
Capture and wipe off any escaping fuel.
3. Install a new fuel pre-filter between the plastic hoses and secure using hose clamps, taking
care the flow is in the right direction.
4. Remove the receptacle.
Replacing the fuel microfilter:
Fig. 53 Fuel micro-filter maintenance
1 Turn in this direction to unscrew the filter cartridge.
2 Filter holder
3 Filter cartridge
1. Place a receptacle beneath the fuel fine filter housing.
2. Use a filter wrench to loosen then unscrew the filter cartridge. Catch fuel in the receptacle.
3. Clean the sealing faces of the micro-filter cartridges and the opposite site of the filter mount
with lint-free cloth.
10 Maintenance
10.3 Engine maintenance
No.: 9_6999 23 USE
Operator Manual Screw Compressor
M100
117
To Next Page
