➤ Allow the machine to cool down.
➤
Do not open the body while the machine is switched on.
➤ Do not open or dismantle any valves.
➤ Use only spare parts approved by KAESER for use in this machine.
➤ Operate the machine only in technically sound condition.
➤ Carry out regular inspections:
■ for visible damage and leakage,
■ of safety devices,
■ of the EMERGENCY STOP devices (if present),
■ of parts needing monitoring.
➤ Pay particular attention to cleanliness during all maintenance and repair work. Cover compo‐
nents and openings with clean cloths, paper or tape to keep them clean.
➤ Do not leave any loose components, tools or cleaning rags on or in the machine.
➤ Components removed from the machine can still be dangerous.
Do not attempt to open or destroy any components taken from the machine.
➤ Self-locking nuts removed for the installation must not be reused but replaced by new nuts, be‐
cause the non-positive safety is no longer ensured.
➤ Use only suitable compressed air hoses.
Compressed air hoses must meet the following requirements:
■ they are of the right type and size for the highest permissible machine working pressure,
■ they are not damaged, worn or of reduced quality,
■ they have couplings and connections of the right type and size.
➤ Wear protective gloves when connecting or disconnecting compressed air hoses.
➤ Make sure compressed air hoses are de-pressurised before disconnecting from the machine.
➤ Secure the open end of an air hose before applying air pressure. An unsecured hose may whip
and cause injury.
➤ At working pressures>100 psi, compressed air hoses should be secured by a cable to their re‐
spective outlet valves.
➤ Connect and operate only suitable air tools.
■ The air tools must meet the set output pressure of the machine.
■ Use a pressure reducer for air tools requiring a lower pressure.
■ Use compressed air tools only with the pressure appropriate for its purpose (tool working pres‐
sure).
3.5.2.4 De-commissioning, storage and disposal
Improper handling of old operating fluids and components represent a danger for the environment.
➤ Drain off fluids and dispose of them according to environmental regulations.
These include, for example, fuel, engine oil and compressor cooling oil and engine coolant.
➤ Dispose of the machine in accordance with local environmental regulations.
3.5.3 Organizational Measures
➤ Designate personnel and their responsibilities.
3 Safety and Responsibility
3.5 Dangers
32
Operator Manual Screw Compressor
M100 No.: 9_6999 23 USE
To Next Page
