7.2.2 Special measures for re-commissioning after storage
➤ Carry out the following before every start-up after long period of storage:
Storage
period longer
than:
Remedy
5 months ➤ Remove the desiccant from the openings in the air intake filters of the engine
and compressor.
➤
Check the air and oil filters.
➤ Drain the preserving oil from the separator tank.
➤ Fill with cooling oil.
➤ Drain the preserving oil from the engine.
➤ Fill with engine oil.
➤ Check the engine coolant
➤ Check the battery charge state.
➤ Reconnect the battery.
➤ Check all fuel lines, engine oil lines and compressor cooling oil lines for leaks,
loose connections, wear and damage.
➤ Clean the bodywork with a grease and dirt dissolving agent.
➤ Check the tire pressures.
36 months ➤ Have the overall technical condition checked by an authorised KAESER Serv‐
ice Technician.
Tab. 68 Measures for re-commissioning the compressor after a long period of storage
7.3 Checking installation and operating conditions
➤ Check and confirm all the items in the checklist before starting the machine.
Check See chapter Confirmed?
➤ Are the operators fully conversant with safety regulations? –
➤ Have all the positioning conditions been fulfilled? 5
➤ Is there sufficient cooling oil in the separator tank? 10.4.1
➤ Is there sufficient oil in the engine? 10.3.4
➤ Is the maintenance indicator on the air intake filters (engine and
compressor) OK?
10.3.2,
10.4.7
➤ Is there sufficient coolant in the coolant expansion tank? 10.3.1
➤ Is there sufficient fuel in the fuel tank? –
➤ Is there sufficient tool oil in the tool lubricator? (option ea, ec) 10.8.1
➤ Is there enough antifreeze in the frost protector? (Option ba) 10.8.5
➤ Are the access doors closed and all body panels in place? –
➤ Are the tire pressures OK? –
Tab. 69 Positioning and operating conditions checklist
7 Initial Start-up
7.3 Checking installation and operating conditions
No.: 9_6999 23 USE
Operator Manual Screw Compressor
M100
73
To Next Page
