16
BASIC SAFETY INSTRUCTIONS
Drive converters contain electrostatic sensitive components.
► Avoid contact.
► Wear ESD-protective clothing.
Do not store drive converters
• in the environment of aggressive and/or conductive liquids or gases.
• with direct sunlight.
• outside the specified environmental conditions.
1.3 Installation
DANGER
Do not operate in an explosive environment!
► The COMBIVERT is not intended for the use in potentially explosive
environment.
CAUTION
Maximum design edges and high weight!
Contusions and bruises!
► Never stand under suspended loads.
► Wear safety shoes.
► Secure drive converter accordingly when using lifting gear.
• To prevent damages to the device:
• Make sure that no components are bent and/or isolation distances are changed.
• The device must not be put into operation in case of mechanical defects.
• Do not allow moisture or mist to penetrate the unit.
• Avoiddustpermeatingthedevice.Allowforsucientheatdissipationifinstalledin
a dust-proof housing.
• Note installation position and minimum distances to surrounding elements. Do not
cover the ventilation openings.
• Mountthedriveinverteraccordingtothespecieddegreeofprotection.
• Make sure that no small parts fall into the COMBIVERT during assembly and wiring
(drilling chips, screws etc.). This also applies to mechanical components, which can
lose small parts during operation.
• Checkthereliabletofthedeviceconnectionsinordertoavoidcontactresistances
and sparking.
• Do not walk-on drive converter.
• Follow all safety instructions!
To Next Page
Loading...
Need help?
General