KEB COMBIVERT F6 Series

23
PRODUCT DESCRIPTION
2.3 Product features
This instruction manual describes the power circuits of the following devices:
Device type: Drive controller
Series: COMBIVERT F6
Power range: 45...90 kW / 400 V
Housing 6
The COMBIVERT F6 is characterized by the following features:
• Operation of three-phase asynchronous motors and three-phase synchronous
motors, in operating modes open-loop or closed-loop with and without speed
feedback
• followingeldbussystemsaresupported:
EtherCAT, VARAN, PROFINET, POWERLINK or CAN
• System-overlapping operating concept
• Wide operating temperature range
• Low switching losses by IGBT power unit
• Low noise development due to high switching frequencies
• Di󰀨erentheatsinkconcepts:
• Temperature-controlled fan, easily replaceable
• Torque limits and s-curves are adjustable to protect gearboxes
• General protection functions of the COMBIVERT series against overcurrent, over-
voltage, ground fault and overtemperature
• Analog inputs and outputs, digital inputs and outputs, relay output (potential-free),
brake control and -supply, motor protection by I²t, KTY- or PTC input, two encod-
erinterfaces,diagnosticinterface,eldbusinterface(dependingonthecontrol
board)
• Integrated safety function according to EN 61800-5-2