EasyManuals Logo

Keba ServoOne junior Device Help

Keba ServoOne junior
493 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #256 background imageLoading...
Page #256 background image
after reversing direction corresponds to the zero point. An offset can be programmed
in the screen.
Image 8.42: Approach block, direction of travel left, with zero pulse
ID No.: 0842.26B.5-01Date: 09.2020
ServoOne- Device Help
256
8 Motion profile
8.5.5Method(-8)and(-9):Movetoblock
Tracking error monitoring is switched off during the homing procedure.
The maximum permissible torque can be reduced specifically during the homing
operation. To do so, parameter P 0225 MPRO_REF_HOMING_TMaxScale must be
set in the range of 0-100%. Note that this parameter replaces parameter P 0332
CON_SCON_TMaxScale during the homing run.
8.5.5.1Method(-8):Rightwarddirectionoftravel
With P 0169 MPRO_REF_HOMING_MaxDistance the tracking error is specified in
the positioning range in which the block is detected.
When the block is detected, the system disengages by half the value in parameter P
0169 MPRO_REF_HOMING_MaxDistance) and the zero point is defined.
An offset can be programmed in the screen.
Image 8.43: Approach block, direction right

Table of Contents

Other manuals for Keba ServoOne junior

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Keba ServoOne junior and is the answer not in the manual?

Keba ServoOne junior Specifications

General IconGeneral
BrandKeba
ModelServoOne junior
CategoryController
LanguageEnglish

Related product manuals