Keba ServoOne junior Device Help

11.6.29.6Error30-6(emergencycode5300h)
Cause: Maximum frequency configuration exceeds HF limit
Suggested steps:
Check max. frequency of device or ask your service provider for HF support
Thisissueisprobably
causedbyanunsuitable
parametersetting.
l Saveyourparametersetforalaterrestore.
l See'historyofparameterchanges'andundo
thelatestchanges.
l Pleasecheckyourparametersetfor
implausiblesettings.
l Pleasesetdevicetofactorysetting,restart,and
seeiftheerroroccursagain.
l Whenreportingthiserrortoyourservice
partner,pleaseincludeyourdevice's
parametersetting.
ID No.: 0842.26B.5-01Date: 09.2020
ServoOne- Device Help
416
11 Alarms & warnings
11.6.29.7Error30-7(emergencycode5300h)
Cause: Error at lookup table (bigtab) calculation
Suggested steps:
Check settings of table configuration
Thisissueisprobably
causedbyanunsuitable
parametersetting.
l Saveyourparametersetforalaterrestore.
l See'historyofparameterchanges'andundo
thelatestchanges.
l Pleasecheckyourparametersetfor
implausiblesettings.
l Pleasesetdevicetofactorysetting,restart,and
seeiftheerroroccursagain.
l Whenreportingthiserrortoyourservice
partner,pleaseincludeyourdevice's
parametersetting.
11.6.30Error31:PLCerror
11.6.30.1Error31-0(emergencycodeFF00h)
Cause: User defined Error detected.
Suggested steps:
Error was triggered by iPLC application (Function: MCB_CTR_SetError). Further
information is available from the programmer of the application!

Keba ServoOne junior Specifications

General

Brand	Keba
Model	ServoOne junior
Category	Controller
Language	English