Keba ServoOne junior - Error 28: Encoder Channel 3, Cyclic Process Error

11.6.27.2Error26-2(emergencycode7305h)
Cause: Channel 1 cyclic, Np (distance coded): error, delta correction failed
Suggested steps:
Please check the wiring of the encoder, perhaps reduce the speed.
Encoderchannel,cyclic
evaluation
l Errorduringthecyclicevaluationofan
encoderchannel1.
l Inanycaselookatinitoutputsinthemessage
windowoftheDriveManager.
l Themostcommoncauseoferroristhewiring
totheencoder.
11.6.27.3Error26-3(emergencycode7305h)
Cause: Channel 1 cyclic, Np (distance coded): error, calculated 'delta' is out of range
Suggested steps:
Please check the wiring of the encoder
Encoderchannel,cyclic
evaluation
l Errorduringthecyclicevaluationofan
encoderchannel1.
l Inanycaselookatinitoutputsinthemessage
windowoftheDriveManager.
l Themostcommoncauseoferroristhewiring
totheencoder.
11.6.28Error28:Encoderchannel3,cyclicprocesserror

ID No.: 0842.26B.5-01Date: 09.2020
ServoOne- Device Help
412
11 Alarms & warnings
11.6.28.1Error28-1(emergencycode7307h)
Cause: Channel 3 cyclic, Np (distance coded): error, measured 'counter distance' is
out of range
Suggested steps:
Please check the wiring of the encoder
Encoderchannel,cyclic
evaluation
l Errorduringthecyclicevaluationofan
encoderchannel3.
l Inanycaselookatinitoutputsinthemessage
windowoftheDriveManager.
l Themostcommoncauseoferroristhewiring
totheencoder.
11.6.28.2Error28-2(emergencycode7307h)
Cause: Channel 3 cyclic, Np (distance coded): error, delta correction failed
Suggested steps:
Please check the wiring of the encoder, perhaps reduce the speed.
Encoderchannel,cyclic
evaluation
l Errorduringthecyclicevaluationofan
encoderchannel3.
l Inanycaselookatinitoutputsinthemessage
windowoftheDriveManager.
l Themostcommoncauseoferroristhewiring
totheencoder.