To Next Page

To Previous Page

11.6.13Error12:CANerror

11.6.13.1Error12-1(emergencycode8140h)

Cause: CAN option: BusOff error

Suggested steps:

Please check cable and terminal resistant

Thedevicewasprobably

disconnectedfromthe

mastercontroller,orthe

masterisoverloaded.

l Pleasecheckthebussystemconnection.Try

toreplacethecables.

l Pleasetrytoreducecomputationalloadonthe

master.

l Trytoincreasethemastercycletime.

ThisispossiblyanEMC

issue.Thisisverylikelyifthe

problemoccurswhen

switchingonmotorcontrol

and/orwhenconnectingDC

linkpowersupply.

l Pleasecheckthedevicecablingforproper

connection.

l Pleasecheckdevicegrounding,i.e.the

connectiontoametalbackplaneandcabinet

connectiontoearth.

l Checkmotorgroundingandmotorcable

length.

ID No.: 0842.26B.5-01Date: 09.2020

ServoOne- Device Help

358

11 Alarms & warnings

11.6.13.2Error12-2(emergencycode8130h)

Cause: CAN option: Guarding error