Keba ServoOne junior - Error 60: Spindle Mlamping Mystem Monitoring Error; Error 61: End Damping Error

11.6.52.2Error58-2(emergencycode6100h)
Cause: Hydraulics, tracking error monitoring: maximum tracking error exceeded
Suggested steps:
Please check the parameterization.
Hydraulics,cyclic
processing
l Errorduringthecyclicexecutionofthe
hydraulics.
l Inanycaselookatinitoutputsinthemessage
windowoftheDriveManager.
11.6.53Error60:Spindlemlampingmystemmonitoring
error
11.6.53.1Error60-1(emergencycode6100h)
Cause: Tool not clamped correctly while in operation
Suggested steps:
Do not switch on drive while tool is not clamped correctly
11.6.53.2Error60-2(emergencycode6100h)
Cause: Unknown combination of input signals
Suggested steps:
Check input wiring and settings
ID No.: 0842.26B.5-01Date: 09.2020
ServoOne- Device Help
453
11 Alarms & warnings
11.6.53.3Error60-3(emergencycode6100h)
Cause: Clamping pressure was not applied properly
Suggested steps:
Check clamping pressure generation
11.6.54Error61:Enddampingerror
11.6.54.1Error61-1(emergencycode6100h)
Cause: End damping speed limitation error
Suggested steps:
Switch off/on device. Please contact your service provider if this error occurs again