Keba ServoOne junior - Error Reactions

Immediately after an error occurs, it will be shown in a window. After closing the
window by clicking on “Quit error” or “Later,” you can view the current error and the
20 most recent errors (see Section "Alarms and warnings (Details)" on page 330).
ID No.: 0842.26B.5-01Date: 09.2020
ServoOne- Device Help
339
11 Alarms & warnings
11.5Errorreactions
l P 30 - ErrorReactionsisusedtodefinehowtheServocontrollerwill
respondintheeventofanerror.Theseresponsesaredefinedindividuallyfor
62differenterrorscenarios.Aselectionofuptoninedifferentresponseswill
beavailable(seeSection"Errorreactions"onpage339).
l P 38[0] - ERR_Specific2OptCodecanbeusedtodefineanadditionalerror
responseiftheServocontrollerfeaturesanoptionalfunctionpackage.
Error reaction Function
Ignore(0)
Ignoreerror
Exception:FortheHWlimitswitch,inwhichcasea
warningwillbegenerated(P 34bit29orbit30)
Specific1(1)
Theerrorwillbereported;theresponsewillbe
carriedoutbytheintegratedPLC(V2.0andhigher)
Exception:FortheHWlimitswitch,inwhichcasea
warningwillbegenerated(P 34bit29orbit30)and
therewillbeaSTOPrequest(decelerationwithramp
dependingontheSTOPoptioncode,withoutany
changetotheDRIVECOMsystemstate).Atstandstill
therelevantdirectionisblockedaslongasthelimit
switchisactive.
Specific2(2)
Theerrorwillbereported;theresponsewillbe
carriedoutbyanexternalcontroller
Table 11.6: Error reactions