Keba ServoOne junior Device Help

11.6.7Error6:Motortemperatureerror
11.6.7.1Error6-1(emergencycode4310h)
Cause: Motortemperatureabovethresholdvalue
Suggested steps:
Wait and let motor cool down. Reduce motor load or change motion cycle.
Themotortemperatureistoo
high.
l Pleaseletthemotorcooldown
l Pleasecheckmotortemperatureandmotor
temperatureresistance(PTCsensorsdonot
reportthemotortemperature).Ifthevaluesare
notplausible,checkcablesandsensortype.
l Ifyouarenotusingasystemmotor,please
checkwiththemotormanufacturerifthemotor
canstandahighertemperature
ID No.: 0842.26B.5-01Date: 09.2020
ServoOne- Device Help
353
11 Alarms & warnings
11.6.7.2Error6-2(emergencycode4310h)
Cause: PTC short circuit detected (DIN2)
Suggested steps:
Please check PTC cable and sensor
Themotortemperatureistoo
high.
l Pleaseletthemotorcooldown
l Pleasecheckmotortemperatureandmotor
temperatureresistance(PTCsensorsdonot
reportthemotortemperature).Ifthevaluesare
notplausible,checkcablesandsensortype.
l Ifyouarenotusingasystemmotor,please
checkwiththemotormanufacturerifthemotor
canstandahighertemperature
11.6.7.3Error6-3(emergencycode4310h)
Cause: PTC/TSS overtemperature, resistance higher than 3500 Ohm
Suggested steps:
Wait and let motor cool down. Reduce motor load or change motion cycle.
Themotortemperatureistoo
high.
l Pleaseletthemotorcooldown
l Pleasecheckmotortemperatureandmotor
temperatureresistance(PTCsensorsdonot
reportthemotortemperature).Ifthevaluesare
notplausible,checkcablesandsensortype.
l Ifyouarenotusingasystemmotor,please
checkwiththemotormanufacturerifthemotor
canstandahighertemperature

Keba ServoOne junior Specifications

General

Brand	Keba
Model	ServoOne junior
Category	Controller
Language	English