EasyManuals Logo

Keba ServoOne junior Device Help

Keba ServoOne junior
493 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #409 background imageLoading...
Page #409 background image
11.6.25.21Error24-45(emergencycode7307h)
Cause: Channel 3 Initialization, SinCos: error, encoder monitoring
Suggested steps:
Please connect the encoder correctly.
Initializationencoder
channel3
l Errorduringtheinitializationroutinesof
encoderchannel3.
l Inanycaselookatinitoutputsinthemessage
windowoftheDriveManager.
l Themostcommoncauseoferroristhewiring
totheencoder.
11.6.25.22Error24-46(emergencycode7307h)
Cause: Channel 3 Initialization: the internal multiturn resolution is too low to process
ENC_CH3_MTBase correctly.
Suggested steps:
Please reduce the internal position resolution to free bits for the internal multi-turn
information.
Initializationencoder
channel
l Thisisprobablyaproblemofthe
parameterization!
l Inanycaselookatinitoutputsinthemessage
windowoftheDriveManager.
ID No.: 0842.26B.5-01Date: 09.2020
ServoOne- Device Help
409
11 Alarms & warnings
11.6.25.23Error24-47(emergencycode7307h)
Cause: Channel 3 Initialization, EndDat22: common error
Suggested steps:
Please note the extended information of the error message
Initializationencoder
channel3
l Errorduringtheinitializationroutinesof
encoderchannel3.
l Inanycaselookatinitoutputsinthemessage
windowoftheDriveManager.
l Themostcommoncauseoferroristhewiring
totheencoder.
11.6.25.24Error24-50(emergencycode7300h)
Cause: Channel 3 Initialization, TOPT: Used FPGA version does not match TechOpt
card functionality.
Suggested steps:
Please update the FPGA to the right version or replace the TechOpt card.
X8optionmodule:Firmare-
orFPGAversionwillnot
work
l Thisisprobablyafirmwareproblem!
l Pleasecheckifthecorrectfirmwareisonthe
servocontroller.
l Inanycaselookatinitoutputsinthemessage
windowoftheDriveManager.
l Iftheerroroccursagain(after24Vreset),
pleasecontactyourserviceprovider.

Table of Contents

Other manuals for Keba ServoOne junior

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Keba ServoOne junior and is the answer not in the manual?

Keba ServoOne junior Specifications

General IconGeneral
BrandKeba
ModelServoOne junior
CategoryController
LanguageEnglish

Related product manuals