Remove pilot pin.
Remove the left half weldment of driven wheel
Disassemble the oil seal on the left half driven wheel
Check the free length of clutch spring
Allowable limit: 68mm。
自由长度：free length
Check the wear of driven wheel\
Measure the outside diameter of right half bushing of driven
wheel
Allowable limit: 32.94mm。
Measure the inside diameter of left half sliding sleeve of
driven wheel
Allowable limit: 33.06mm。
14.6.1 Replacement of right half of the driven wheel
bearing
Remove needle bearing on the right half of driven wheel
Remove cir-clip and outside rolling bearing
Attentions:
The removed bearing cannot be used any more
滚动轴承：roller bearing 滚针轴承: needle bearing
弹性挡圈：circlip
To Next Page
Loading...
