Maintenance Regulations
During the maintence of the motorcycle, please use the metric instruments whenever possible, improper
instruments may cause damage to the motorcycle.
Before the maintainence operation of disconnecting or opening the protecting plate, please eliminate the pollution
outside the parts or assembly parts to prevent the pollution fall into the motor, bottom plate or brake system.
After disconnecting and before measuring the wear value, please
purge the components and blow through with the air compressor.
The rubber parts may deteriorate because of aging, which is
extremely damaged by solvents or oil. Therefore it should be
checked before reassembly and replaced when necessary.
When loosing the components which have many assembly parts,
the loosing sequence should be from exterior to interior, and the
samll assembly part should be loosed first.
The complex assembly part such as speed gear box shall be
stored in proper sequence for the easy assemble in the future.
Special attention should be paid to the important attachment
postions before disassembly. The non-used components should
be replaced in time before disassembly.
To Next Page
Loading...
Need help?
General
